Processing instructions and application information

Clean the substrate

Apply the adhesive tape (important: do not touch the adhesive surface) and press down firmly with a spatula

Remove the masking film and stick on the object with high pressure

Observe dwell time, full load-bearing capacity after approx. 24 hours

The fastening side or bonding partner must be dry, dust-free and free of release agents and oils in order to achieve a durable bond. In case of contamination, pre-clean with technical alcohol if possible . Use cleaning cloths for one application only. For tiles and similar surfaces, additional drying with e.g. a hair dryer is recommended. The optimum application temperature (adhesive partner and environment) is between +15 °C and +30 °C. Mirrors and adhesive tape should be pre-stored for 24 hours at this temperature. The quantity of adhesive tape determinedon the following table according to the bonding scheme (see Figure 5 and 6) to theback of the mirror and press firmly into place. Please note that the maximum length of an adhesive strip must not exceed 50 cm. To check for excessive unevenness at the fixing point, the mirror should be held against the surface to be glued with an adhesive tape cover. After removing the protective cover, the mirror is then pressed firmly onto the fixing point.